Leave Your Message
Preformed Permanent Anti-stain pavement marking tapes (Smooth Surface)

Permanent Anti-Stain Road Marking Tapes

Preformed Permanent Anti-stain pavement marking tapes (Smooth Surface)

Preformed Permanent Anti-stain pavement marking tapes does not contain glass beads on the surface. It is made by combining high-performance coatings, flexible polymer, wear-resistant layer, substrate, high-strength adhesive, release film, and other materials.

    Product Information

    Brand: Cai Lu
    Item No.:L5020X(without adhesive backing),L5021X(with adhesive backing)
    Color: white, yellow, red, blue, black, green

    Product Features

    --The surface is free of glass beads, smooth surface, and easy to clean. The base material of the preformed material is composed of polymer flexible polymer rubber, fillers, pigments, etc., and a layer of high wear-resistant and environmentally friendly paint is planted on the surface. It has the characteristics of strong wear resistance,  good weather resistance, long durability, and convenient and quick construction.
    --The main advantage is that it is resistant to dirt and eye-catching, even if it is dirty, it is easy to clean. It can be made into various marking lines, arrows, characters, patterns, color signs, logos, color three-dimensional signs, pipeline signs, etc.
    --It is suitable for rubber products, concrete, asphalt, cement, marble, epoxy floor, ceramic tile, etc. It is basically suitable for bonding various floors and walls. This product is recommended for indoor use on various floors and surfaces that require anti-pollution and dirt resistance. Works best on walls.
    --According to the condition of the road surface, the flow of people, and the installation situation, the service life can reach at least 3 years.

    Product size reference chart

    Product number Length(M) Width(CM) Thickness(MM) Weight(±10%) Conventional packaging Adhesive
    L5020X 50M 5,10,15,20,Customizable 1.0-1.5MM 2.0kg/sqm 260*260*400MM without adhesive backing
    L5021X 50M 5,10,15,20,Customizable 1.2-2.0MM 2.2kg/sqm 260*260*400MM with adhesive backing

    Technical Indicators

    Nature

    General data

    Unit

    Test Methods

    L50211

    L50212

    ________

    ________

    Color

    white

    yellow

    ________

    ________

    Thickness

    1.3

    1.3

    mm

    GB/T 7125

    Water resistance

    pass

    pass

    ________

    GB/ T24717

    Acid resistance

    pass

    pass

    ________

    GB/T 24717

    Wear-resistant

    40

    40

    mg

    GB/T24717

    Minimum adhesion

    25

    25

    N/25mm

    GB/T24717

    Instructions

    1. The pavement marking tape without adhesive backing is commonly used in special environments and special materials, using special glue, such as two-component AB glue, 502 glue, etc.
    2. The products with adhesive backing can be divided into ground brush primer and ground primer without brush according to the usage:
    Without brush primer on the ground: It can be directly applied to smooth and flat surfaces without applying primer when used indoors, on outer pavement, and on various walls of place such as workshops, exhibition halls, squares, safety islands of toll stations, where few vehicles run over, it only needs rip off the isolated paper on the back of the product and sticks it directly to the joint surface. And its life can be 5 years to the longest.
    Brush primer on the ground: It should be applied with primer on uneven surfaces or walls(e.g., Pattex Contact Adhesive, Maxbond UL 1603HFR-HS). The amount of primer required depends on the smoothness of the bonding surface, approximately 1 kilogram per 3 to 5 square meters. Please refer to the construction instructions when using the primer.

    description2